I have the NVR-ELE32-4K and am able to do all the basic things with my "unsupported" ONVIF cameras, but getting the NVR to handle the motion detect has been annoying. I know I can setup the cameras themselves to handle this and have, but to get them to send the emails and such I would need to connect them to the router rather than safely hiding them behind the NVR. The problem is on the motion detect screen the configuration fails to load for every camera no matter what I do. I understand these aren't supported cameras so I don't expect the remote config to work from the NVR, but the cameras are already configured and I just need to make the NVR respond and email when the camera says motion is detected. I did find a "loophole" for channel 1 - for some reason when it initially tries to load channel 1 it fails, but if I move to channel 2 (or any other channel) and then back to channel 1 it will work properly and allow me to save everything properly. That still leaves all the other 31 channels nonfunctioning for motion detect and it only works when connecting from another computer (doesn't work from software on the nvr directly).
So is there anything I can do to get the other channels working with motion detect or am I just stuck since I didn't buy my cameras from you?