Have 16 channel hikvision nvr that was giving me some problems.
I did a factory restore then a current version update.
I cannot control the nvr, most of the options are greyed out.
Cannot assign an ip address - it is set to automatically assign one.
The device names are ++++++++++++++++++++++++
Camera names are +++++++++++++++++++++
Cannot turn off upnp.
Looks like I need to wipe the nvr clean and do a fresh install but the system will not permit me to do so.
May have to remove the battery ?
It will not even allow me to shut it down.
I have to use the on/off switch.
It is off at the moment and I am using another nvr.