Thanks for the quick reply:
It did not configure the PTZ options on the DVR yet. I don't know which protocol, baud rate, etc to use.
I used the white BNC connector on the camera. The yellow one is a RSA type. I thought this would be for a wrist size display to check the camera in place.
I did set the camera to TVI using the toggle at the camera pigtail. Default was AHD, if I'm not mistaken. I changed the DVR setting under "Camera Signal" to TVI from default AUTO (TVI/AHD). It did not make a lot of difference on the picture quality, though.
There was another setting in the same menu on the DVR: Lite off/on. I could not find anything in the manual about this option.
I have a picture of the night image, but unable to add it into this post. 🙁 . I could email it.
Thanks for your help.
Marius